Applications:

Car head-lights and tail-lights test.

Life, current, burn-in and short circuit test for lights and all lamps in automotive and motorcycle industries. 

Technical features:

-CPU armed for control

-Switching power supplies with over-temperature and short-circuit pretection

-Solid state relays, FET switch technology

-Alphanumeric LCD display, 4 x 20 characters

-16 keys keyboard with security key for test parameter protection

-PLC level I/O signals

-One high power switching power supply for every part

Technical characteristics:

Number of outputs	5, 10 (1 or 2 lighters, one lighter with 5 lamps max)
Evaluation loads	Power or current
Display	Backlighted LCD, 4 rows of 20 characters
Keyboard	16 keys, with security lock key
Interface	RS 232, for data transmission
Number of programs	4
Test modes	2 (automatic or manual)
Output voltage	11 V – 15 V DC
Maximum output current	13 A limited
Maximum lamp current set	0 ~ 9,999 A
Minimum lamp current set	0 ~ 9,999 A
Lamp test time set	0 ~ 9,999 S
Number of part tested	1 or 2 (simultaneously)
Number of lamps for one part	Up to 5
Non linearity error	Lower than 0.3 %
I/O	PNP type, PLC compatible as standard (NPN on request)
Power supply	230 VAC as standard, 110 VAC on request
Dimensions	440 x 290 x 355 (w x h x d)
Original calibration	Made using calibrated and traceable references
Warranty	1 years

Working principles:

This power supply and tester is designed to perform the following tests for lamps, LED assembled in rare lights, head lights in auto and motor industries.

♦ Life test (Initial pre-ignition): provide all the outputs with programmable time

♦ Burn-in test: set number of blinking cycles, and programmable ON and OFF times during cycles ♦ Short circuit test

At the power on, the instrument loads the test parameters from its internal nonvolatile memory and wait for start signal START 1 or START 2 inputs, If the inputs are activated simultaneously, the instrument starts testing both part 1 and part 2.